MSefi.com read only forum (Jan.15,2018)

I am mounting a Delphi 42 lb/hr injector into a intake runner I am trying to sketch up in Solid Works. The problem I have is figuring out what part of the injector should come in contact with the mounting hole. I will be holding the injector down using a cap and 2 bolts which will be tensioned. This ...

Can I please get clarification on "control the start of fuel timing".

Am I going to want to use a trigger wheel and a VR sensor?
Is the MS1 with the PCB3.0 the setup I want to go with?

Speedy:)

Hello all,
It has been a long time since posting. I have built a MSII for a Corvette engine project which is on hold. Now I am in engineering school and have taken on a senior design project which is using a 2.5 hp single cylinder engine converted over to propane. I have made the choice to use MS ...

Thanks for all the responses. As of yet I don't have the Busa throttle bodies. I was looking at running the busa fuel injectors and fuel rail since the 944 stock intake manifold, fuel rail and injectors were damaged in the engine fire. If I use the busa stuff I can cut the mounting flange from the ...

I have built a MSII about a year ago to run my Vette LT1 motor swap into my '87 Porsche944S. I have since been layed off of work and now going to school full time for mechanical engineering. Since time and money is low now I am thinking of going a different route with the 944S project.

I am ...