Search found 2 matches
- Sun Jul 19, 2009 6:51 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: Trigger wheel setup
- Replies: 6
- Views: 654
Re: Trigger wheel setup
How did you cut those holes so accurately on the pulley?
- Sun Jul 12, 2009 5:44 pm
- Forum: Wiring and Sensors
- Topic: Where to get power for the EDIS module?
- Replies: 1
- Views: 250
Where to get power for the EDIS module?
Where is a good place to pick up the switched 12V for the EDIS module? I didn't want to use the same source as the +12V switched power for the relay board since the EDIS switched 12V powers the coil and so forth. It was suggested to use the injector +12V terminals on the relay board, however ...