MSefi.com read only forum (Jan.15,2018)

well this sensor type did work ok at one time not to long ago. i have already used the ice water and the boiling water trick and i have the right resistance scale. i am using a distributor. an trigger angle is at 60

i am using direct coil control. last time it was on the stim it seemed normal. went up an down like it should have with the pots.
when i look at the logs it goes from regular temps to just wild swinging. hold 180.1 then jump to 300+. then swing back. it usually reads insanly high all the time for ...

ok here goes the story. i switched code on my ms2 v3 to extra had bad luck with it, went back to regular code. 2.89. ever since i switched the code i started to get funny readings on the temps. i have re calibrated the therm tables an all that jazz. even tried a new sensor to see what would happen ...

got her working how it is supposed to! now im off to pop in a distributor then start on the spark side of life. thanks again.

hey, the reason i have it set to narrow band in the projects folder was becouse that was the only way the gauge would work in ts. i modifyd the gauge to read from 1 to 5v. when i switch it to wide band in the project folder it would compleatly kill the gauge. i had the ego set to wb in ts though. if ...

as the topic states this is the problem. i have got a ms2 v3 with 2.888 code. now the wide band reads ok does its 0 through5v thing. now when i set it to wide band from narrowband in ts the ego and afr gauge quite working and i get no read out from the wb in ts. is this in the code or what settings ...

ok cant get it to lean out on idle and got a bad stumble off of the bottom bins. any ides

ok i got it to run today but its still giving me trouble when im tryin to start it. when i got it up to temp got it idling it would fire right back up. i left it set cleaned the plugs up and went back an then it would not fire up an stay running. in order to get it to started today i had to knock ...

ok i am going to work on it now. so u dont think it is in the box an that i just need more fine tunning. ok i will give her a shot an tell youns what i come up with.

forgot the msq. sry just been scatter brained lately this is the one i have been trying to fire it on.

ok i think what i can see is a droped tach signal maybe still kinda very new to this world. thanks again.

i have a 87 rabbit just freshen up the block slightly and put itbs on it. i built the board myself. it is a ms2 v3. what i cant get is that when i go to fire the car it will crank ant run but it will only run for about 5 seconds then it is like it is starving out. i am trying to do alpha n. but i ...