MSefi.com read only forum (Jan.15,2018)

i wouldnt even know where to start with water injection. so that might be pushing it.

the top revs would be about 6500 i would think. I have heard of these motors test bedded by suzuki run for days straight at revs over 10k but 6500 would be as far as i would be likely to push it.

being a 4x4 the ...

is it possible to setup the pipe to not be quite as powerful but to work over a wider power band?

yeah they werent the most powerful things out there.

the 4 cyl four strokes in the newer ones were only about 45hp

tanshi wrote:from stock they had 26 horse power, lol
50 hp would be nice but probably unrealistic.

as for revs, just before it goes bang would probably be the limit

opps i meant 26 kilowatts

its about 35 HP and would like to push it up to 50-60 if possible

from stock they had 26 horse power, lol
50 hp would be nice but probably unrealistic.

as for revs, just before it goes bang would probably be the limit

oh and by a pipe do you me a tuned expansion chamber?
if so,
then no i only have the factory one at this stage. i am hoping to find some one who knows about improving performance on the two stroke at some point.

im trying to get more power, while keeping it relyable. reliability its the most important thing.

reeds from a snow mobile might be hard to come by as im from some where that is thousands of miles from anywhere with snow.

It is a reed valve motor. Im looking at bigger reed valves from a suzuki outboard Motor which bolt straight on.

If i was to run them in one bank, i would have them only fire once per full engine revolution? When in the cycle would be best to firethem?

i would have thought that while one bank would ...

Im located in Brisbane, Australia.

Custom work sounds good.

its not a recent motor at all, Its actually from a suzuki 4x4 car from 1974 :) an LJ50 is the model. Triple throats from a triumph 700 cc motor cycle

Im not real good with the solder etc, is there any one around the place that does good work and could put the MS together for me including the mods i ...

I have a 500cc 3 cyl 2 stroke motor that im putting together a parts list for injecting. I have a set of triple injected throttle bodies that im fabbing a mainfold for.
my question is:
How do i run the three seperate injectors using a MS as i understand that the MS 2 only has two seperate channels ...