MSefi.com read only forum (Jan.15,2018)

Awesome! Thanks Matt, this simplifies everything... even the knock inputs can go through here.

Hello,

I'm looking to add a CAN bus device to my MS setup and looking for a way to wire up the CANH and CANL. They are on the recommended spr1 and spr2 ports.

I notice on my version of the Relay board, there is a ports there labeled as spare ports 1 - 4 on top of the FIdle relay. I've been ...

Lance,

Thanks for the reply.

I'm pretty sure I have the trigger wheel setting are correct as well. The sensor is mounted on the 10* mark when the #1 cylinder is at TDC. Since the first tooth after the missing tooth on 90* BTDC, this gives me skip teeth of 8.

So I was tinkering around some more ...

Hey Guys,

I'm hoping to get some help here on my setup. Built up my MS a year ago and hooked it into my car, but mostly in a passive mode (just logging). My intentions were to slowly migrate over to FI one element at a time. My first hurdle is ignition.

My MS setup is getting a RPM reading ...