MSefi.com read only forum (Jan.15,2018)

and tested with several different edis-4 engines, engine capacity and all with the same result, something very strange is that all modules have the same numbering.

What can happen?, All on the same revs and different engines is very strange.

at home with the stimulator works well, I have the limit at 8000rpm with fuel cut when it gets to 8000rpm and the pulse is 0.

You don't have an oscilloscope by any chance, do you?

I have no oscilloscope Matt, I'm trying to buy a digital one economical, but so far I have not

What do you see?


the truth is that I'm thinking about making on without edis-4, direct ms2 and coils 36-1 over the wheel, so read is not much work and can be a solution, although I have some doubts, know whether to ms2 to microsquirt to one given problem

one last thing, configuraon reading your content, it says to ger off-set = 0, I have 2.5 can cause this problem?, I do that for the stimulator works well but not so sure.

It sounds like the module has a built in 6750 RPM rev limit. Offset can be used to compensate for a slightly "off" trigger wheel and should not be the cause of the problem. The offset merely shifts the timing by the number of degrees entered.

ok Matt, I will make direct contact with the wheel rolls 36-1, habrire a new topic in assembly, thanks for the help.