Page 1 of 1
Will the Bosch 93490 Temperature sensor work with MS-II
Posted: Sat Sep 17, 2005 7:15 am
by Mad Professor
Hi All.
Just a quick one.
Can anyone tell me if the standard Bosch 93490 temperature sensor will work with my MS-II?
Thanks for your time.
Posted: Sat Sep 17, 2005 7:20 am
by Mad Professor
In the Autodata Book page 448 there is a page giving a tolerance of various readings that go like this.
-10°C 8.2-11 k ohms
+20°C 2.28-2.72 k ohms
+40°C 1.0-1.5 k ohms
+60°C 600-700 ohms
+80°C 290-370 ohms
+100°C 180-220 ohms
Posted: Sat Sep 17, 2005 8:26 am
by efahl
Professor,
Yes, that sensor will work just fine. When you start up MegaTune, go to Tools -> Calibrate Thermistor Tables... and you'll see the MS-II equivalent of EasyTherm. Just pick the extreme and middle points off your table above, type them in and hit return.
Eric
Posted: Sun Sep 18, 2005 7:45 am
by Mad Professor
Ok cool.
But what is "bias resistor"?
Posted: Sun Sep 18, 2005 8:58 am
by Mad Professor
Ah righto.
The MS-II was built with only the standard parts.
Posted: Sun Sep 18, 2005 9:09 am
by Mad Professor
I set it up by the following
-10°C 9600 ohms
+60°C 500 ohms
+100°C 200 ohms
Will this be ok?