Page 1 of 1
Source for Male Bosch connectors?
Posted: Thu Mar 30, 2006 10:40 am
by sportage4x4
does anyone know of a source for male bosch connectors? the female ones are easy enough to find, but i've searched and searched and cant find any place that sells male ones. more specifically, a 3 pin male connector, as used on some bosch 3wire PWM idle air motors, bosch TPS's, some bosch knock sensors, and bosch hall sensors.
anyone have any ideas?
2pin male connectors i've found. i guess some people use those to extend injector harness leads.
Posted: Thu Mar 30, 2006 10:53 am
by mickeymarrows
These days I always leave a breakers yard with a pocket full of bosch/amp connectors. Strip em down, stick em in the dishwasher and re use with new pins....
Posted: Thu Mar 30, 2006 10:56 am
by PSIG
mickeymarrows wrote:...Strip em down, stick em in the dishwasher and re use with new pins....
You are apparently NOT married...
Posted: Thu Mar 30, 2006 11:47 am
by sportage4x4
haha, in the dishwasher, yeah, and sleep in the garage for a week!
of the few male connectors i've found most have the pins and leads moulded in. perhaps i need to search the junk yards harder.
Posted: Thu Mar 30, 2006 1:41 pm
by keithmac
I think they`re called Junior Timer Connectors, have a seach for that and see what comes up, I use
http://www.vehicle-wiring-products.co.uk, postage may6 not be that bad?
Posted: Thu Mar 30, 2006 1:41 pm
by Mike_Robert
See what happens when you get caught ceramic coating exhaust parts in the oven.... that one cost me a new oven!
Posted: Thu Mar 30, 2006 2:33 pm
by sportage4x4
excellent resource, thank you.
they seem to carry 2 pole male housings, but not this blasted 3 pole version i need. bah!! why bosch! why!!
i'll do some more searching with this new "junior timer connector" search string.
Posted: Thu Mar 30, 2006 2:42 pm
by keithmac
VW use 3 pin JTC`s for Bosch hall senders.
Posted: Thu Mar 30, 2006 2:48 pm
by thedge
Try
www.eagleday.com they have 2 pins, cant remember about three pins.
Posted: Thu Mar 30, 2006 3:08 pm
by sportage4x4
just checked, only 2pins male.
the bosch hall sensor is precisely what i need, i need to extend the sensor from the loom, but i dont (cant) cut the plug off the loom, so i need a Male and a Female, the female is easy enough to find at any of the above mentioned sources. it seems as though the male is non existant.
Posted: Fri Mar 31, 2006 1:39 pm
by keithmac
It is possible it dosen`t exist, the bosch hall sensor connector isn`t like a normal JTC if I remember correctly, similar but not identical..
Posted: Fri Mar 31, 2006 4:58 pm
by sportage4x4
i've pretty much concluded it is non existant. so i'll have to raid the scrap yard and see how many i can find on pigtails from knock sensors.