Page 1 of 1
Posted: Thu Jun 29, 2006 9:34 am
by tlivingd
I don't think you can use the fuel pump relay, dosen't MS have a timer to run the fuel pump for only about 2 seconds from inital key to on then it turns off. then MS waits for an ignition signal to turn the pump back on?
-nate
Posted: Thu Jul 13, 2006 4:15 am
by lani16
does it work from the main relay? because i just posted a question for a 7 pin hei setup and was thinking of hooking it up to the fidle relay but if it works from the main relay then i could use the fidle relay for my TCC
Re: edis power off relay board
Posted: Tue Dec 02, 2008 4:46 pm
by phj420
why cant you just run it through your ignition switch? you have the wire at your relaybox already. just run an inline fuse to the edis.
Re: edis power off relay board
Posted: Sat Jan 03, 2009 8:21 am
by Ollie8974
Connect it to the S5 terminal on the relay board.
Re: edis power off relay board
Posted: Sat Jan 03, 2009 9:01 pm
by vinister
I run mine off the main ignition relay that powers the MS.
Re: edis power off relay board
Posted: Wed Jan 07, 2009 10:51 am
by loren
I just used an Injector feed terminal. For my application (TBI), I'm only using one of the two Injector circuits (and only one of the four terminals). So, I put a fuse in the unused Injector circuit and used it to power the EDIS and the LC-1.
Otherwise, why not just use the factory wiring? Surely your stock power block has a fuse for "coil" or "ignition". No real need to go through the MS Relay Board at all.