MSefi.com read only forum (Jan.15,2018)

Im hoping to use the OEM knock sensor to help keep in check my agressive tuning, (ecu is tested but not yet installed though)
The engine is a Toyota 5mge (1986 ADM Cressida Glxi) transplanted into an Ma61 (ADM 5me) using MS2 on the v3 board.

The instructions on the knock sensor seem to mention a seperate module to feed the input into ms but the stock sensor goes straight to the ecu.
Iam a bit of an electronics noob so Im not sure how to handle this.

Any tips on this engine especially the knock sensor would be much appreciated.

Cheer, Tim

Enchanter wrote:Im hoping to use the OEM knock sensor to help keep in check my agressive tuning, (ecu is tested but not yet installed though)
The engine is a Toyota 5mge (1986 ADM Cressida Glxi) transplanted into an Ma61 (ADM 5me) using MS2 on the v3 board.

The instructions on the knock sensor seem to mention a seperate module to feed the input into ms but the stock sensor goes straight to the ecu.
Iam a bit of an electronics noob so Im not sure how to handle this.

Any tips on this engine especially the knock sensor would be much appreciated.

Cheer, Tim

See Here - viewtopic.php?t=9636

and this web site for the KnocksenseMS - http://www.viatrack.ca

im also using MS2 v3 in my 4age toyota engine.

can i directly connect the OEM knock sensor to MS2 (PIN JS4)?

can it damage my CPU,? i think that the oem knock sensor produces low voltage.