Page 1 of 1
turbocharged Yamaha rhino MS-II ?'s
Posted: Sat Feb 10, 2007 12:50 am
by TurboToy94
I have all the wiring diagrams for the rhino, but I'm not sure what type of signal the "AC Magneto" puts out?? I know I need to have the MS interupt the signal from the Mag., to the CDI box, but is it considered a "VR" or "Hall" sensor? And am I going to have a problem getting it to run a single injector? Or should I build an intake with two injectors? I searched for anyone who has done this, but didn't really come up with anything, there is some guys talking about MS-ing a single cylinder engine with a Mag, so I know it can be done. Can one injector be hooked up with both inj. bank out-put wires from the MS? Or can the MS be set-up for just one bank (one inj.)?
Thanks
Posted: Sat Feb 10, 2007 1:15 am
by arlo#1
It should be a vr sensor. We in the motorcycle industry call them trigger coils If you probe it with a oscilloscope and the wires unhooked to the cdi You shoud see around 3 volts ac at cranking. You should have no problem running one injector. Realy anything is possible If you put your mind to it!
Re: turbocharged Yamaha rhino MS-II ?'s
Posted: Sat Feb 10, 2007 2:31 am
by newtyres1
TurboToy94 wrote: Can one injector be hooked up with both inj. bank out-put wires from the MS? Or can the MS be set-up for just one bank (one inj.)?Thanks
Just use one injector output. I have a 2 cyl with 2 injectors (high impedance) running from just one injector output. Works fine. MS doesn't know or care if you have anything connected to the 2nd injector output.
Ian.
Posted: Sat Feb 10, 2007 3:59 am
by TurboToy94
Sweet, Thanks guys.
Later