Page 1 of 1
dwell on the stim
Posted: Sun Feb 08, 2009 8:06 am
by wildwestsydney
Hi All MSII version 3.0 board. While checking thing out on the stim I noticed that the dwell gage does not vary much with changing inputs. It reads right around 1 plus or minus .3. the dwell setting are max dwell duration 3.1, max spark duration 2.0, acceleration comp .6. I would think from this the gage would read around 3.
I am running 2.889 code
Re: dwell on the stim
Posted: Mon Feb 09, 2009 6:35 am
by Matt Cramer
wildwestsydney wrote:I am running 2.889 code
If you go back to 2.888 code, does the issue persist? 2.889 is not a stable release and has a couple bugs.
Re: dwell on the stim
Posted: Tue Feb 10, 2009 4:51 pm
by wildwestsydney
Matt Cramer wrote:wildwestsydney wrote:I am running 2.889 code
If you go back to 2.888 code, does the issue persist? 2.889 is not a stable release and has a couple bugs.
I have not tried going back a code level. I will. Should the dwell in megatune be around what you set in dwell settings?
thanks
Sam
Re: dwell on the stim
Posted: Wed Feb 11, 2009 6:40 am
by Matt Cramer
It is around the dwell settings except at very low RPM where it may sometimes increase - this was a trade off to improve accuracy.
Re: dwell on the stim
Posted: Thu Feb 12, 2009 6:17 pm
by wildwestsydney
I loaded a lower code and it and the dwell gage reads what it should.