Page 1 of 1
EDIS boots
Posted: Mon Mar 30, 2009 2:35 pm
by jagdude
Hi,
Anyone have a reliable source for the spark-plug wire boots for the EDIS coilpack? I found Boost Engineering but there were a few comments about the length of time for them to respond. Anyone had any experience with them??
Thanks,
Jim
Re: EDIS boots
Posted: Thu Apr 02, 2009 8:05 pm
by BottleFed70
You mean for the coil pack end?
If so, I wasn't able to find anyone who sold them. Most people pull the boots off a set of JY wires and crimp/make their own plug wires.
Re: EDIS boots
Posted: Fri Apr 03, 2009 4:44 am
by jagdude
What are JY wires???
Jim
Re: EDIS boots
Posted: Mon Apr 06, 2009 6:28 pm
by kholman
JY=junkyard, I think
Re: EDIS boots
Posted: Tue Apr 07, 2009 5:04 am
by jagdude
kholman wrote:JY=junkyard, I think
I see.
Thanks,
Jim
Re: EDIS boots
Posted: Sat Apr 11, 2009 2:48 pm
by S.Bretz
MSD makes a set of coil tower convertor things for there edis wire kits. This adapts the weird clip on coil hole into a normal mail tower that accepts a female plug wire. I used a slighlty different set for v8 distributor and got them to work, but they are slightly different dimensionally from the the true convertors.