MSefi.com read only forum (Jan.15,2018)

as the topic states this is the problem. i have got a ms2 v3 with 2.888 code. now the wide band reads ok does its 0 through5v thing. now when i set it to wide band from narrowband in ts the ego and afr gauge quite working and i get no read out from the wb in ts. is this in the code or what settings do i have buggerd up so that it wont read.

I'm sure Phil (author of TS) would have a better idea. I would advise you post this on the TS forum.

Did you try making a new project and specifying WBO during the project setup ?

Did you try going into dash designer and assigning the correct variable to the gauge?

I'm a bit confused - why are you setting it to narrow band in the tuning software if you are using a wideband? Or did I misread what it is you're trying to do?

after you set the "EGO" to wideband, you need to calibrate the "AFR tables" (in the top menu, same place where you calibrate your TPS and your temp sensors) for they type of wideband

hey, the reason i have it set to narrow band in the projects folder was becouse that was the only way the gauge would work in ts. i modifyd the gauge to read from 1 to 5v. when i switch it to wide band in the project folder it would compleatly kill the gauge. i had the ego set to wb in ts though. if i tried turning on the ego correction it would try to pull dead lean all the time. Now i did not know about the calibrate afr table thing. i will try that an let youns know how that works. thanks again people!

got her working how it is supposed to! now im off to pop in a distributor then start on the spark side of life. thanks again.