MSefi.com read only forum (Jan.15,2018)

MS2 PBC 3.0 B&G 2.98

here http://www.DIYAutoTune.com/tech_article ... _board.htm it says dwell should be around 2.0ms.
Question is, should i set to 2.0ms in MT and it shows on gauge 1.7ms or should i set to 2.3ms so that gauge will show 2.0ms

Best regards

WASyL,

Typically this means to set the dwell parameter Maximum Dwell Duration (ms) to 2.0 milliseconds. The actual dwell will then be lowered a bit by the voltage compensation, and this is totally fine. There is more on setting dwell here: http://www.megamanual.com/ms2/configure.htm#dwell

Lance.

thanks Lance

i have memorised whole megamanual for MSII code B&G 2.8 but i wanted to make sure by asking additional question to confirm what i have understanded as english is not my native language

best regards