MSefi.com read only forum (Jan.15,2018)

Posted: **Mon Jun 28, 2010 4:26 am**

Hi all, my first post, so please be kind.

Currently gathering all bit's & pieces to EFI my 1968 Morris Mini 1310 A series. I will be using MSII v3.0, a single injector in a TBI (wet manifold) configuration, running a standard mild cam. Can I get away with running MAP only, or do I have to use TPS as well? If I can do MAP only, where in Tunerstudio do you setup for this, or where can doco be found for this?

Thanks in advance.

Jim

Posted: **Mon Jun 28, 2010 9:44 am**

MAP-only should be fine. Just specify MAPdot acceleration enrichment in Acceleration Wizard and ground the TPS wire so as not to trigger flood clear mode.

Posted: **Mon Jun 28, 2010 3:46 pm**

Matt Cramer wrote:MAP-only should be fine. Just specify MAPdot acceleration enrichment in Acceleration Wizard and ground the TPS wire so as not to trigger flood clear mode.

Thanks for the info Matt.

MSefi.com read only forum (Jan.15,2018)

MAP Only on 'A' Series Engine

MAP Only on 'A' Series Engine

Re: MAP Only on 'A' Series Engine

Re: MAP Only on 'A' Series Engine