Page 1 of 1
Constant Baro Ground
Posted: Mon Oct 10, 2011 5:46 pm
by Daryl
On the independent baro installation page of the manual the 'non-banded end of D1' is recomended for the ground on the V3.0 board, which is incorrect and should be changed.
Is there a problem using the DB9 end of R57?
Thanks
Daryl
Re: Constant Baro Ground
Posted: Tue Oct 11, 2011 4:58 am
by Matt Cramer
That should be OK, or you could use SG or the proto GND.
Re: Constant Baro Ground
Posted: Tue Oct 11, 2011 12:27 pm
by Daryl
Thanks Matt,
I'm afraid I followed the manual, not knowing the problem till it pegged the reading, and started checking for grounds. The end of R57 is close enough that I have just pulled the jumper from D1 to move to R57 without any other mods / longer wires etc.
Daryl