MSefi.com read only forum (Jan.15,2018)

they use the same sensor used that write up

its ok to have something different.

what car and modes have you done to the car.

im in willimantic 06226.

im not a guru but i have some experience where in NE you are located.im in ct

that happen to me a while back and i solve the problem contacting the injector manufactor and ask them for the injector dead time and problem solve duty cycle down and a much better idle.hope that help

hi i would like to know how many people have noise problem with low ohms injectors if you do what you did to cured it.thanks

any megasquirt will work on your set up if i was you i would get a ms2 v3 board and let the ms do the spark control.just my 2 cent

i always ground the sensors to the ms and my ms and related stuff to the battery and im not having a single problem with noise in any signal.

diy are great with custumer satifaction and dude you can use the haltech sensor they are gm.

haltech used gm sensors.

yes you dont need the resistor ms will run the inj with no problem.

all you have to do is wire them in pair to the same inj. output as matt said.

i would said that size the injectors for the h.p that you think that the engine its going to make and run the 8 injectors at the same time.(one inj,per runner) cyl.1 and 4 to channel 1 and 2and 4 on channel 2.