Well, in case anybody cares:
I set up the DIS coil with one tower going through a test light to ground, and the other tower to the center terminal on the distributor cap.
Hooked up the primary wires and fired it up.
Ran good for about 30 secs then died.
Determined the VB921 was dead.
No problem, I ...
Search found 2 matches
- Sat May 19, 2012 2:26 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: DIS coil in distributor configuration?
- Replies: 1
- Views: 246
- Sat May 19, 2012 9:08 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: DIS coil in distributor configuration?
- Replies: 1
- Views: 246
DIS coil in distributor configuration?
I have a distributor based ignition setup.
was wondering if I could use a DIS coil in place of the regular single tower coil?
maybe possible to ground one high tension lead from the DIS coil to the engine block and route the other lead to the center of the distributor cap?
i already have a few GM ...
was wondering if I could use a DIS coil in place of the regular single tower coil?
maybe possible to ground one high tension lead from the DIS coil to the engine block and route the other lead to the center of the distributor cap?
i already have a few GM ...