Driving it as guessed direct from the EDIS, however I've been having continuing peoblwms with the EDIS still going into limp home mode and the rev counter surging all over the place.
Enquiries are ongoing!
Search found 3 matches
- Thu Sep 04, 2008 3:29 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: SAW Voltage
- Replies: 4
- Views: 442
- Sun Aug 31, 2008 6:54 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: SAW Voltage
- Replies: 4
- Views: 442
Re: SAW Voltage
Problem found!
Turned out to be dry joint from the 5v supply from the proto feed.
Turned out to be dry joint from the 5v supply from the proto feed.
- Sat Aug 30, 2008 7:40 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: SAW Voltage
- Replies: 4
- Views: 442
SAW Voltage
Hello
MS II Version 3, code 2.68
I had this set up running perfectly with my Zetec and EDIS 4.
Yesterday the timing became fixed at 10 degress (Limp home mode for the EDIS 4 when no SAW signal received), I've scoped the SAW and instead of 5 volts it's varying between 0.5 and 1.0, the signal is ...
MS II Version 3, code 2.68
I had this set up running perfectly with my Zetec and EDIS 4.
Yesterday the timing became fixed at 10 degress (Limp home mode for the EDIS 4 when no SAW signal received), I've scoped the SAW and instead of 5 volts it's varying between 0.5 and 1.0, the signal is ...