MSefi.com read only forum (Jan.15,2018)

I have knock settings problems. I have MS2 with code 2.88. Boris knock sensor wired through IAC2B (no idle control) strait to JS4, noting that Boris sensor is 5v so it can be handled directly. With the default megatune settings (threshhold(V) 0v, knock threshold 2v) I get a slow knock retard 1 degre...

Problem sorted, well sort of. According to what Ive read I have low impedance injectors, so I used the resistor pack from the donor car. I bypassed the resistor pack and she fired right up. so the car runs, sounds fine, but now I have to find out why they are acting like High impedance. Maybe they a...

Lance, Did you have a look at my msq? Ok just reading the link you gave me, which Ive read about 10 times but just then noticed The after start enrichment starts out at a user-defined percentage enrichment value (typically around 20%), and ramps down to 0% after so many ignition trigger events as I ...

the only thing I can think of is it may be in flood clear mode. How can I tell.

Another point which I didn't think was important is my TPS max calibration is about 460 from memory. whether it's contributing to the problem I don't know.

From what Ive read on a sucessful setup. MS&S on a car, it should be fine if you have simultanious injection to have it off just one of the outputs. I chose bank 1 for personal preference. (it's not going yet but this is not the problem) Im hoping to have duel rails in the future.

yes, whenever the fuel pump is on the pressure quickly spikes to the set pressure and holds until the pump is turned off. Although it is a $40 from ebay. Would it be worth swapping back with a stock one just in case? Is there anyway to test them, feed the inlet with the compressed air and seeing wha...

ok so here's the datalog and it desn't look right. It's only a portion of it as it was long. Another thing is I have simultanious injection only operating from one injector output. I hope to run duel rails down the track. I have also reloaded the code a few times which seems to have fixed my interme...

When I crank my engine it sounds like it wants to start but doesn't. It has good spark and fires but sounds like it's not getting enough fuel but when I raise the cranking pulse widths it doesn't get any better The longest Ive been able to get it to run for is about 3 seconds. The timming is set to ...