Search found 4 matches
- Thu Sep 08, 2011 7:57 am
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: MS-II daughter bd on V1.01 board.
- Replies: 3
- Views: 229
Re: MS-II daughter bd on V1.01 board.
That helps alot, do you know of a help or manual page or forum that address the V1.01 mods?
- Wed Sep 07, 2011 5:36 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: MS-II daughter bd on V1.01 board.
- Replies: 3
- Views: 229
MS-II daughter bd on V1.01 board.
I purchased a blue MS-II daughter board in 2007 and couldn't get it to work thinking it was a problem with the trigger signal for the EDIS. It turned out to be dirty connectors in the EDIS system, but I had already re-installed the MS-1 processor with the pin bent up. I'm back trying to get the MS-I...
- Sat Aug 13, 2011 9:12 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: EDIS 6 Coil Pack Dead
- Replies: 2
- Views: 169
Re: EDIS 6 Coil Pack Dead
Just in case you are still working on it, I had the connectors kill my 6 coil, it took Deoxit D5 to restore the connection.
- Sat Oct 25, 2008 12:18 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: EDIS-6 module output
- Replies: 1
- Views: 201
EDIS-6 module output
I have a megasquirt-II upgrade and I'm installing a junkyard EDIS VR and module using a 36-1, 8" trigger wheel from DIY. I'm trying to set the timing for "limp home mode and I'm not getting a hot enough spark to trigger two different timing lights. I pulled #1 wire off its plug and put an ...