MSefi.com read only forum (Jan.15,2018)

Hi!, read this section http://www.megamanual.com/v22manual/sharesen.htm hope it helps. Good luck!

Hi!, you can see the VR circuit in the MS-II schematics page : http://www.megamanual.com/ms2/pcb.htm . I don´t know that motorbike, in my case, it has a sealed ignition module and I´m not sure if you can drive it with MS, perhaps with an extra circuit..

Hi! they are simply coils with a magnetic element inside, when a ferromagnetic element pases near changes its magnetic field producing a voltage signal.. They are strong, but if you have that spikes and worked fine before, maybe thats it. They are common, but come with different resistances. If you ...

Hi! check the values of the resistance vs. temperature configuration ( Mega therm for MS-I or tools>thermistor calibration in Megatune for MS-II). Good luck!

Hello!, I´m using an MS-I for the ignition on a 97cc Honda 4 stroke bike and works fine, the only thing I had to do was to build the VR input circuit (MS-II has it) in orther to get the signal from the VR sensor and also build a circuit for replacing the original CDI ignition. Good luck!

ok! thank you very much, i´ll test it with the tester made with the audio card, thanks!

Hi! i´m above to run a MS-II PCB 3.0 in a 4 cylinder engine. My question is if I can use a 62 -2 tooth wheel at 10.000 RPM and if it works well, I´ll use a VR sensor for the signal, thanks!