MSefi.com read only forum (Jan.15,2018)

Hi you guys.

just dialing in my tuning, & three days ago my VE tables became inaccessible in both tuner studio and MSII.

If I go to my other car, everything is still fine in MS1.

Go to MSII & no access. The dropdown menu has VE in gray instead of black.

Accel wizard, warmup wizard, & IAT menus ...

Thanks Matt.

Hi you Guys:

I have MSed 2 cars & have the same conclusions on both:

When I try to tune them to.5 volt on a narrowband sensor they always seem too lean.

Preamble:
Both motors are flat air cooled 4 cylinder 1220cc. ( Citroen)
One has throttle body & MS1
One has multiport & MSII 2.89
Both have ...

You might try my shop in Berkeley.

I have MSQd two cars successfully, but if I'm here on the forums looking for answers I'm obviously not a full Hero just yet.

Jaan

http://www.eddinsmoto.com/

Thanks for the idea Don.

It never occurred to me that a transistor might actually serve as a firewall too.

Installed a VB192, & a jumper from the J10 to the Q16 area. It's off to see if it works on the car.

Jaan.

OK:

Answering my own questions.

There is no IGBT in position Q16 on the V 3.57.

That would slow me down.

Does anyone know where to grab an ignition signal off a MS II daughterboard to trigger an external ignitor ?

Or anyone know where to find references on jumpering a V 3.57 board ?

Thanks ...

Some more information:

When running my jimstim 1.3 board I get similar results: The Ign LED stays dead.:

If I jumper the Ign led to pin 36 no action.

If I ground the led jumper instead of going to pin 36 the LED comes on.

The stim is operating & triggering injectors.

I would think pin 36 should ...

Hi everybody:

Been digging through the forums with a ferver, but haven't found an answerto my particular question yet.

I have a 3.57 with an MSII daughterboard. A VR distributor, Jumpers at J1 & JP1 set for a VR, with the cover off you can see the injector LED flash when cranking so I seem to be ...