MSefi.com read only forum (Jan.15,2018)

Thats what I thought, I just wanted to be sure from you guys.Thanks Devastator and Matt. I'll just order the 65lb./hr. Low Impedance Delphi's from you then Matt. I'm saving up for them now. That should cover the bases and give me enough 'spread' for the H.P. rating I'm targeting, without the ...

I am attempting a Flex Fuel system. I have my shortblock completed 4.375X4.15, at 500 cubic inches, V-8, Stroker motor, Edelbrock Single Plane,(MS-II V 3.57 with M.P.I.&1200 CFM 4 hole throttle body) I am having difficulty 'sizing' my Injectors. From the calculators on the MS site I need at least 44 ...

Thanks Matt. I'll wire it in series and have the option to either pull the connector or remove the wire from the relay board which would probably be easier. Those connectors can sometimes be a pain to unplug.

Thanks Matt, Heribet! I have another question. I was playing around with the module and relay board today and also noticed the pull connector that Ford uses to place their vehicles into base timng. I tapped the pull 2 wire connector that connects the PIP/Spout wires and pulling the end of the ...

I see. I think I understand now Heribet. The shielded cable that ford used was simply metal wrapped tape, very thin, with a small piece of stranded wire 2" in length that contacted the #7 wire and wrapped up with the VR and PIP/Spout wires. I wondered why they simply left that piece of wire in the ...

Let me get this straight Heribert, and THANK YOU for helping me. OK I should run the #7 wire alongside the VR sensors wires and the PIP SAW wires and wrap the wires together in metal tape as the factory did? Then terminate the #7 wire instead of grounding it, right? I seem to be more confused now ...

You are correct, Shield is refering to the shield covering the wires. Pin 7 is ground for both the VR sensor wires andt the PIP and SAW wires they go to ground. Excellent! Thank you Sir! So I can run the pin#7 wire from the Edis-8 module to a ground source, correct? I will use either the battery ...

Can anyone help me figure out where the #7 wire from the 12 pin edis module goes to? The Mega manual states it goes to shield. The number 7 wire from the edis module shows 'shield' on the VR sensor wires,(4&5), and 'shield' on wires 1&3 which are the PIP and SAW,(Spout) wires. What does the shield ...

Thanks Heribert. Answers some very specific questions I had. Radially compressed. Makes perfect sense now!

I'll attempt to find the correct answer to that 'problem' or potential problem.