Hi Heribert,
thanks for the reply; the problem is I don't have a scope and I am not an "elecronic guru".
Do you have a schematic for me how to connect the transistor?
Would it maybe also work to add just a resistor(poti) on the input side of the tach to put the load down, but still let enough ...
Search found 2 matches
- Mon Nov 03, 2008 9:50 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: EDIS4 - tachometer goes mad at 7500RPM
- Replies: 2
- Views: 376
- Sat Nov 01, 2008 10:29 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: EDIS4 - tachometer goes mad at 7500RPM
- Replies: 2
- Views: 376
EDIS4 - tachometer goes mad at 7500RPM
Hello!
I am using MS 2 with an EDIS 4 setup; I was using pin 2(IDM) on the EDIS module to drive my Autometer Shift-Lite tach - but at 7500 rpm the needle starts to flicker heavily. So I tried pin 11 (should be the CTO) of the module to see if there is a difference - but there wasn't one at all!
On ...
I am using MS 2 with an EDIS 4 setup; I was using pin 2(IDM) on the EDIS module to drive my Autometer Shift-Lite tach - but at 7500 rpm the needle starts to flicker heavily. So I tried pin 11 (should be the CTO) of the module to see if there is a difference - but there wasn't one at all!
On ...