MSefi.com read only forum (Jan.15,2018)

OK, I guess I will just set the MAP and RPM average bins 4 and hope it works.

I have a MS V2.2 with MSII daughterboard. Since I have an old board and ac only install the 1.31 of the firmware I have different setting than the manual. Can someone give me a description of these settings and a recommended starting value.

General settings
1 - MAP average BINs
2 - RPM average BINS ...

Figured it out. I took everything apart and found the hood on the DB37 connector rubbed the shilding off two wires and shorted them out with the metal hood. Everyting is working fine now.

I have a MSII using the recomended GM manifold temp sensor. The sensor is reading high. When it should be 60 degrees it is reading 300 degrees. I replaced the sensor with a new one and it does the same thing. Any ideas?