MSefi.com read only forum (Jan.15,2018)

I tried to adjust teh sugnal delay but it dosen't seam to do anything, but i did notice that the red light on the mallory that is supposde to be a constient red when running (flashes with every spark signal so it appears as alays on) at the higher rpm's starts to flicker as if it were loosing signal ...

the truck does run the way i have it wired, but i am having trouble with the timming at idle i have it set to 10 btc it reads that with both the light and on the dshboard of megatune but as i rev up the light does not match the megatune dashboard the light will read 22 degrees at 2500 and megatune ...

i have them both set to 3.4 that is what the coil specs are without the controller i did this that way if the controler goes bad i can rewire it and go and when i used this controler before ms it worked fine

one outher question i forgot is can a low dwell setting cause a missfire at high rmp and not at idle?

i am running a msII controller with version 2.886 code from B&G. i would like to use a mallory hifife cd ing contoller with my ing setup but did not see any information withen the manual on how to set it up. from whit i can tell, i think it should be hooked up the same as the msd6 becouse these two ...