Search found 3 matches

by Noel
Wed May 02, 2012 9:06 pm
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Going distributorless
Replies: 2
Views: 502

Re: Going distributorless

Thank you Old Guy. PS , old men rule , that is , when the little lady is not at home.
by Noel
Thu Aug 20, 2009 5:38 pm
Forum: Injectors, Fuel & Air Supply
Topic: Another IAC head scratcher!
Replies: 2
Views: 428

Re: Another IAC head scratcher! (: Solution found

A light turned on in my head in the middle of the night. I looked at my IAC warm up table and discovered that the full warm-up count (IAC seated)was set to a count value less than the Cranking count in Idle Control. So, be advised , set up the IAC warm-up table first with a large count spread , say ...
by Noel
Tue Aug 18, 2009 10:00 pm
Forum: Injectors, Fuel & Air Supply
Topic: Another IAC head scratcher!
Replies: 2
Views: 428

Another IAC head scratcher!

I cant get the IAC to extend back out from its full retracted position more than about 3/10 of an inch. It needs to extend out 5/8 in. to be seated after warm up. If I enter a small start value and a larger cranking position count and then start turning MS on and off the IAC valve will move further ...