so got spark finally. It was the coil pack wasn't recieving a full 12v because i wired the power to the module then to the coil when i put the coil on its own power wire got spark.
but I still don't get an rpm signal in megatune..... any ideas on this one. Also megatune doest show throttle response ...
Search found 3 matches
- Thu Oct 01, 2009 8:24 am
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Need help with EDIS (no spark)
- Replies: 5
- Views: 398
- Wed Sep 30, 2009 7:35 am
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Need help with EDIS (no spark)
- Replies: 5
- Views: 398
Re: Need help with EDIS (no spark)
turns out i dont have fuel either and no rpm on the megatune ideas what would cause this?
- Tue Sep 29, 2009 2:45 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Need help with EDIS (no spark)
- Replies: 5
- Views: 398
Need help with EDIS (no spark)
Ok so I have the v3 main board and relay board running ford edis ign. I have fuel (plugs get wet after cranking) but no spark. On the megatune I have no RPM reading while cranking also it always says not cranking in the lower left corner. I have 2.5v on the "saw" going to the relay board and 0v on ...