Just a few quick things. Firstly, posting your MSQ file will provide all that info without the mega long post. Check your Required fuel calc, and you're using a separate VE and AFR table, but have no o2 sensor attached, so no feedback to use the second table.
yeah, i figured the .msq file has ALL ...
Search found 3 matches
- Wed Sep 16, 2009 11:34 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: 4AGZE wants to start but gurgles out
- Replies: 2
- Views: 275
- Mon Aug 31, 2009 1:09 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: 4AGZE wants to start but gurgles out
- Replies: 2
- Views: 275
4AGZE wants to start but gurgles out
MS II v3.0 Running 2.89
-the injectors are 7mgte injectors (resistor type)
-distributor is the NA 4age with a 4 tooth trigger wheel (VAST type)
i've been battling with this setup for a while. i installed the missing injector drivers. the car now tries to turn over and if i modulate the gas pedal ...
-the injectors are 7mgte injectors (resistor type)
-distributor is the NA 4age with a 4 tooth trigger wheel (VAST type)
i've been battling with this setup for a while. i installed the missing injector drivers. the car now tries to turn over and if i modulate the gas pedal ...
- Sat May 30, 2009 6:23 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: VR signal input > RPM > Direct Coil Control
- Replies: 15
- Views: 1355
Re: VR signal input > RPM > Direct Coil Control
i hope this is still on topic.
i'm working with a turbo 4AGZE setup. i'm using the VAST distributor (4 tooth). megasquirt II v3.0 board.
the unit was pre-assembled. a jumper is installed on D1 and all the recommended jumpers on the bottom of the board were all already completed. i asked this on ...
i'm working with a turbo 4AGZE setup. i'm using the VAST distributor (4 tooth). megasquirt II v3.0 board.
the unit was pre-assembled. a jumper is installed on D1 and all the recommended jumpers on the bottom of the board were all already completed. i asked this on ...