MSefi.com read only forum (Jan.15,2018)

When VE live is turn on does it use 2.5 volts as 14.7 AFR? The reason I ask this is INNOVATE0_5_LINEAR uses 2.35 volts as 14.7 AFR when I try to tune my engine the AFR is always adjust it rich and stop there. I I manual change the VE table to make it 14.7 then turn on VE Live it
puts it back to rich.

Fix it.
Project.properties file was corrupt, created a new one. It works now.

Using TS 1.06 Click on VE Analyze Live, then Start Auto tune, comes back saying Table inactive. What don't I have set up right?

Phil sent me your phone # so I can call you, Can't change the speed with hyperterm.

I try a pin of 1234 that did not work, I think like you said, its set at try wrong baud rate. Sent me that program and I will try it out.

With it connected to megasquirt MS1 extra running at 9600 baud, trying to connect to a Lenovo A1 tablet I get Paired but not connected message on the setting page. When I run Shadow logger I get Unable to connected to Bluetooth adapter. Also when I try to pair it it ask for a
pin to pair with.

I just received your bluetooth adapter and can not get it to work. I down loaded HyperTerminal to my laptop and can not talk to it at either
9600 or 19200 bps. I followed the instructions in the user manual and still can not get the A command to work. What am I doing wrong?

Make sure that the TPS pot has very little play between the shaft and the pot. Some TPS's do not have a return spring in them so if there is
play between the shaft at the pot your TPS reading will change at idle.

Make sure your wiring to the TPS is correct. If the 5 volts is wired wrong it will cause crazy reading at idle.

The only way you can burn up a TPS pot is by wiring up the 5volts wrong. Use a ohm meter and measure between the pins, the two pins that read about 5K ohms and don't change when the pot arm is moved, is where the 5 volts and ground should connect. If the 5 volts is connected to the wiper on the TPS ...

Did you copy the matfactor,thermfactor,throttlefactor.inc files over to My Documents\TunerStudioProjects\MyCar\inc after you used easytherm? If you didn't TunerStudio and Mega Tune will read different.

I had the same problem, found out I set MegaTune for my wideband sensor but set TunerStudio for the wrong one. Compare the AFR table in
TS on what you set in MT, if there different you have problems.

The Bosch CHT sensor for a type 4 is a 10mm x 1mm thread about 13mm long.

I use the VDO one and wired up the circuit for EGT to measure the head temperture on my type 4 engine.

Make sure your AFR tables are set!

Thanks, That did it.

I have version 2.44 and that field is not under Help.

Where can one find out what the meaning of the list of items that can be displayed, like Gego,Gair, TPSacc and others.