Search found 4 matches

by shannonspringer
Sat Feb 06, 2010 12:29 pm
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Cant figure out edis
Replies: 4
Views: 708

Re: Cant figure out edis

is was the vr sensor. i also install a ground strap to the base of the coil. i dont know if that helped or not.
by shannonspringer
Wed Feb 03, 2010 6:18 pm
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Cant figure out edis
Replies: 4
Views: 708

Re: Cant figure out edis

I am using the factory plug wires and ngk plugs. roughly 10k per wire. I am also using the factory ford trigger wheel. what do you mean by plus feed? I ran a external 12 volt power supply to double check i was getting enough voltage. 14.35 volts. I verified with plug out and grounded to engine ...
by shannonspringer
Wed Feb 03, 2010 6:09 am
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Cant figure out edis
Replies: 4
Views: 708

Cant figure out edis

Just installed Edis 6 and i cant figure out why its not working. I have the vr sensor hooked up correctly and I have 12v at to the coil and ignition module. i disconnected PIP and SAW and i still didn't get any spark. I just bought this kit from boost engineering and it was all supposed to be tested ...
by shannonspringer
Thu Jan 21, 2010 9:56 pm
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Ignition miss, inconsistent spark
Replies: 1
Views: 310

Ignition miss, inconsistent spark

Im running megasquirt II version 3 on a 260z. code 2.89 Car starts fine and runs with a little misfire. when it misfires wideband goes super lean (21.9) car idles and has pretty good power doesn't hesitate or die. when checking with timing light i saw light miss a beat and also just around. im using ...