MSefi.com read only forum (Jan.15,2018)

Just wanted to close the loop on this one. Long story short, I've resolved my ignition issues by going back and confirming all wiring/connections. I've got good spark now and ~10 degrees advance with SAW disconnected. Started with a base MS2 config and adjusted only what I needed for my particular ...

@Dave,
That's actually what I was trying to get through over the course of two weekends. Never could get the engine started, that's when I decided to ask for assistance. I'm re-reading the config and initial tuning sections of the manual as well as the physical verifications mentioned earlier ...

Roger that.

This is part of a restoration project I'm doing on the car and as is often times the case, life gets in the way. I'm back to working on it again after about 6 months so I'm in the process of retracing all of my wiring and comparing it to the documentation to confirm that I didn't ...

The setup
77 MGB, 1800cc (stock) MS2 v2.891, controlling fuel and spark, twin TBI (30lbs/hr hi-z injectors), edis4

The issue
On the bench everything test fine with the stim. In the car I can't get it to start. Occasionally it will backfire.

I started with a base ms2 project in tunerstudio and ...