MSefi.com read only forum (Jan.15,2018)

So here is a new question for ya,is the jimstim capable of producing a tach signal for testing the vr circuit? I have everything else up and running but can't get a rpm reading no matter what i do.The manual says the stim isn't capable but if you cranck on r52 and r56 you should be able to get a ...

I have the same issue as the previous poster,i have mine set up for vr and the manual says the jimstim isn't set up for this.I have turned both pots on the ms board an can get no rpms or O2.It does say to test the o2 you can power the unit down move the o2 adjuster and power it back up.You should ...

it was a blank(new)MS-II duaghterbouard with nothing in it.I think i figured it out(used a diffrent puter)i still think i had port problems.Thank you for your help.

ok i found the com port under settings and sure enough it was set to 3 changed it to com1 and megatune will start no problem but after changing to com1 the box says click to test and i get no response (with the megasquirt hooked up and plugged in).I still am in bootloader mode and haven't gotten any ...

I seem to be having port problems with the computer but cant seem to figure it out.when i run the portchecker.exe it comes back 4 available ports but doesn't see the megasquirt-II.I don't have anything else running(no printers or faxes that i can find).Can ya direct me as to where to look to make ...

Ok so i downloaded it into the desktop,and followed ALL the directions.When i try to open it from the shortcut on the desktop it tells me controller code does not match signature in Megasquirt-II.ini
It then says Expected "MSII Rev2.88600"(found in ini.file)
Recieved"0x51"(from controller)
table ...