MSefi.com read only forum (Jan.15,2018)

Cam sensor would solve the problem. Now you can get one injection pulse every 720 degrees crank tied to the intake stroke. This is the same problem the guy had on this thread

3.5hp Briggs and Stratton

Mr old guy is there a conversion to tag on to the camshaft with a sensor of some kind of a one ...

I'm sure there is a reason reed switches are not used, being stuborn to a fault is sometimes one of my features. I 'm looking for a hall effect switch for plan b, I'm wrong a lot but I learn alot.

See my post regarding injection determination questions on the Briggs 10hp -Hall Effect ignition ...

newbe here.
question on the injection doing
Are you injecting for every other spark event?
how do you tell you are injecting on the intake if you are using the flywheel sensor?
I can't get to the thread last mentioned in your post (been dropped) do you know what they tried to do?

I'm trying a reed ...

Does your application require you to control the ignition with the MS. If it doesn't I would just use the stock ignition module and either use a hall sensor on the flywheel or an inductive pickup off the plug wire to get your tach signal for MS.

Yes - H2 burns up to 10 times faster that gasoline ...

Been out of pocket
This is a Briggs and scrap iron engine module. The wire is the kill wire, take it to ground and the engine dies.
On the reed switch front 60 hz required for 3600 RPM is no problem for a reed switch as most literature I find says 200 Hz is a good test frequency to determine point ...

Thanks old guy you are probably right. I’m not to savey on hall effect switches is there a model that might work? I’ll do more searching on this. One other option is to use a magnetic reed switch and see if I only get one point break per rev and not 2 because of the 2 magnetic poles.

I would like to run a MS2 - V3.0 board on a generator engine the coil is a solid state item controlled by a magnet (N and S poles next to each other) on a flywheel. Does anyone know what kind of signal is generated on the kill wire when it is open? Can this be used to drive the VR input to the MS2 ...