It worked,
8 Delay Teeth and Trigger Offset adjusted with Trigger Wizard.
I put the VR sensor and TSEL signal on an oscilloscope to set the potentiometers. I get a nice wave signal from the VR sensor, where the trigger at the missing tooth goes from negative to positive and a steady square output ...
Search found 3 matches
- Mon Mar 26, 2012 10:14 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: Major Problem with Ignition Settings
- Replies: 3
- Views: 496
- Mon Mar 19, 2012 5:40 pm
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: Major Problem with Ignition Settings
- Replies: 3
- Views: 496
Re: Major Problem with Ignition Settings
Thanks a lot Lance,
I never understood the issue with the tach teeth. I also just learned how missing tooth and delay teeth interact with each other. I read these websites you did give me a hundred times already :RTFM: , but could never got a clue what these guys wanted to tell me.
What I'll do ...
I never understood the issue with the tach teeth. I also just learned how missing tooth and delay teeth interact with each other. I read these websites you did give me a hundred times already :RTFM: , but could never got a clue what these guys wanted to tell me.
What I'll do ...
- Mon Mar 19, 2012 8:03 am
- Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
- Topic: Major Problem with Ignition Settings
- Replies: 3
- Views: 496
Major Problem with Ignition Settings
Hi there,
I got a MS-II V3.0 and using firmware 2.905.
Since a few weeks I am trying to set the Spark timing right and can't get it. :?
Usually it is knocking, so the spark is too advanced. I don't know, if there is any problem with my Ignition Settings or whether it is up to the Potentiometers ...
I got a MS-II V3.0 and using firmware 2.905.
Since a few weeks I am trying to set the Spark timing right and can't get it. :?
Usually it is knocking, so the spark is too advanced. I don't know, if there is any problem with my Ignition Settings or whether it is up to the Potentiometers ...