MSefi.com read only forum (Jan.15,2018)

Ok, strange that the board doesn't have the driver because I thought all later boards came with it. I'll ask DIY to install one and do a diagnostic of the entire board. As far as how how it runs now without one, I can only say that I've completed wiring as if the driver is installed. The factory ecu ...

Is it possible that the 3.57 board was ordered without the coil driver? Do I need to install one?
I tried again to set timing and that thing is all over the place! I could get no repeatability or pattern by moving the trigger offset angle around. 60adv would get me 60 sometimes and sometimes I would ...

I uploaded some wiring information for my dizzy in this thread, and my msq is loaded also. Can you get to those answers from that? I thought I was controlling spark w MS. I have the dizzy wired to terminal 15 on the relay board, and the coil on terminal 11. If I config MS to spark based on my dizzy ...

What does that mean for my setup? Am i missing a vital component? Is that one of my starting/idleing issues?

Attached is a photo of the entire board. Which of the 7 of those legged ones is the one?

Farq! is mine MIA?

I'll have to wait until this evening and right now it's just after noon here in Dallas.
The firmware was 2.88 if that gives any indication of which module was used.

By the way, I uploaded the 2.920 ini tonight. Go me,

I'm not sure what module comes with the stock turbo distributor. Does this help you?

How would one go about determining that?

See the attachments. I compiled wiring diagrams and written instructions from ZCar.com, DIY, Hybridz.
I struggled with the wiring, primarily because I'm not sure I identified the neg terminal correctly on the coil.

firmware is MS2 2.885

Okay I ran the timing light again this evening (fuel pump fuse pulled out), these are my findings:
No matter what I set trigger offset at I could not tell any change in timing. I went from 10deg retard to 5 to 0, to +5, +10, +15, +20, +25. Each time the timing mark was showing somewhere around 30ish ...

Thanks. I have had RPM above 300 and while using the same cranking pw. Trigger angle is a different story though. I have had the same rough idle at 2deg btc as I have with 40deg btc, both built within Trigger Angle. Confused,
Check out this log attached. I have issues with repeatability. For ...

Hey I've also got a thread started in the wrong location, somewhere over in MSExtra. I was properly chastised that I was using the wrong forum so I'm moving over here.
I've got a 280zx with t3/t4 and ic, 44# low imped injectors, and 60mm throttle body, LS1 wb o2, factory coil, factory optical dizzy ...