MSefi.com read only forum (Jan.15,2018)

Hi If i have read upgrades correctly you can remove the 40 pin prossesor that came with the ms1 and install the ms2 in its place and make some other mods. some one else out there may know more on this?

will a ms2 daughter board fit an ms1 2.2 controller

found the problem, the engine was getting way to much air I had to really richen it up to compensate I found it by disconnecting one of the three throttle bodys and the engine rev. fine accually ran very well. I went into the ve table and had to adjust it. I may end up using just two throttle bodys....

Yes I have a wide band o2 lc-1 I will send you the logs soon. engine would not restart last night no matter which download I used from tunerstudio as soon as I downloaded from megatune it started could this problem be my cable from the controller to my lap top. I have to use a usb to db9 adapter cab...

I have a new set up on my hot rod and I am also new to all this but so far having fun. not sure if this is the correct place to post his cond. but here goes. I have set up a 350 chevy with a 6-71 blower that has been using 2 600 holleys and now has been set up with 3 2.5 throttle bodys from a 4.3 v6...