Search found 5 matches
- Wed May 25, 2016 6:33 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: MS2 V3 Idle solenoid setup
- Replies: 3
- Views: 734
Re: MS2 V3 Idle solenoid setup
it is a megasquirt 2 , daughterboard. or what do you by MSQ,
- Mon May 23, 2016 8:33 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: MS2 V3 Idle solenoid setup
- Replies: 3
- Views: 734
MS2 V3 Idle solenoid setup
i done it on MS1Extra with no problem, but this one is confusing me, i just want to control a solenoid or relay (just on-off)
under "Idle Control" i selected Solenoids at 140* i can change my temp on the simulator and my LED on the megasquirt goes on and off as i go higher or lower on temp, but have ...
under "Idle Control" i selected Solenoids at 140* i can change my temp on the simulator and my LED on the megasquirt goes on and off as i go higher or lower on temp, but have ...
- Sun May 15, 2016 7:54 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Problem with MSII daughterboard
- Replies: 3
- Views: 758
Re: Problem with MSII daughterboard
thanks trakkies , that was the problem, finally i got it to start,
- Thu May 05, 2016 3:38 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Problem with MSII daughterboard
- Replies: 3
- Views: 758
Re: Problem with MSII daughterboard
with the MS2 chip loaded with 2.905 , it let me open tuner studio and check it and it shows ms2
- Tue May 03, 2016 3:47 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Problem with MSII daughterboard
- Replies: 3
- Views: 758
Problem with MSII daughterboard
i am building the V3 board with EDIS, this is my 4th one the other 3 i done MSextra with no problems, after built and with mods for EDIS placed an MS!extra chip and tested fine with simulator, but when i place the ms2 chip the fuel pump led just flashes, the MS2 chip has the software 2.920, then i ...