MSefi.com read only forum (Jan.15,2018)

Thanks Dave!

I'm going to do as you mentioned and wire them in 2 groups, I do need to decide which pairs to group. I think to even out the distribution the best they should be 1&4 and 2&3. That's what I came up with in my head, and read that others had used the same (assuming a 1342 firing order ...

My previous MS experience is with a TBi setup, and now that i'm going to multipoint i'm faced with trying to figure out how to wire my injectors.

MY problem is I can't figure out if I should fire all four, or split them into 2 batches of 2 firing alternatly. Wiring them isn't the issue, it's ...

Thanks Matt, the article is very helpful.

On my first MS install a few years ago I converted a carb'd engine, and while it was still running on the carb I had the MS hooked up to all the sensors and was able to datalog and check that I wasn't getting resets. It also ended up logging the ignition curve of the stock dizzy, though I never used ...

OK, getting a little closer with my own MS installation this week.

I have a inlet manifold and TBI setup off a G16a 8 valve Vitara. I went and pulled the coolant temp sensor from it last night to get some figures to punch into Easytherm, and I spotted a 2nd sensor installed in the manifold pretty ...