I'm fairly new to the forum and am in the process of gathering hardware and info to convert my Ford stage 2 V6 essex 3.1L.
I want to port inject but the current inlet manifold doesn't give much room to fit injectors onto the middle two cylinders on each bank due to the twin choke webber position. Ford fitted these engines to Ford Transits and used a single ventui carb on these engines because the required horsepower wasn't as great. This manifold would overcome the problem but I worry that it will strangle the engines potential.
Is there a calculation formula I can use to determine the optimum orifce(s) I need in the inlet manifold for my particular engine.
Any info greatfully receieved.
Graham
Throttle body size. Is biggest best?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
YellaYomper
- MegaSquirt Newbie
- Posts: 2
- Joined: Thu Dec 14, 2006 3:07 pm
- Location: Banbury, Oxfordshire UK
-
YellaYomper
- MegaSquirt Newbie
- Posts: 2
- Joined: Thu Dec 14, 2006 3:07 pm
- Location: Banbury, Oxfordshire UK