Megalogviewer VE kPa change

For discussing B&G MS-I/MS-II set-up and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
fineline
MegaSquirt Newbie
Posts: 1
Joined: Mon Jan 21, 2008 9:05 pm

Megalogviewer VE kPa change

Post by fineline »

So I got my truck running and driving. I datalog with megaTune and use Megalogviewer to analyse my VE table. My initial VE kPa starts at 20 and maxes out at 220 kPa. When I look at the Ve table in the analyzer it only shows a kPa max value of 100? When I save it it changes the values as well to a max of 100 kPa? How do I change this or get megalogviewer to recognise 220 kPa?

Thanks,
Brandon
Top
kholman
Site Admin
Posts: 127
Joined: Sun Dec 24, 2006 5:56 pm

Post by kholman »

Does this address your issue?
viewtopic.php?p=189630
Top
Post Reply

Return to “Tuning Fuel and Air”