Hi,
Anyone have a reliable source for the spark-plug wire boots for the EDIS coilpack? I found Boost Engineering but there were a few comments about the length of time for them to respond. Anyone had any experience with them??
Thanks,
Jim
EDIS boots
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
BottleFed70
- MegaSquirt Newbie
- Posts: 31
- Joined: Fri Jun 24, 2005 2:22 pm
Re: EDIS boots
You mean for the coil pack end?
If so, I wasn't able to find anyone who sold them. Most people pull the boots off a set of JY wires and crimp/make their own plug wires.
If so, I wasn't able to find anyone who sold them. Most people pull the boots off a set of JY wires and crimp/make their own plug wires.
1970 Ford Mustang
351W Single T70 Turbo 6 PSI
MSII, v3.0 PCB, v2.889 firmware, Megatune 2.25
351W Single T70 Turbo 6 PSI
MSII, v3.0 PCB, v2.889 firmware, Megatune 2.25
Re: EDIS boots
What are JY wires???
Jim
Jim
Re: EDIS boots
I see.kholman wrote:JY=junkyard, I think
Thanks,
Jim
Re: EDIS boots
MSD makes a set of coil tower convertor things for there edis wire kits. This adapts the weird clip on coil hole into a normal mail tower that accepts a female plug wire. I used a slighlty different set for v8 distributor and got them to work, but they are slightly different dimensionally from the the true convertors.
MS2 v3.0 pcb, 2.891 firmware w/ flex fuel mod
Ford eDIS-4
1000cc injectors
Saturn 1.9L
....lots of boost with a 50 shot of anti-lag.
Ford eDIS-4
1000cc injectors
Saturn 1.9L
....lots of boost with a 50 shot of anti-lag.