I'm connecting up all the wires now to the megasquirt, one wire on my V3 diagram is labeled Ignition module/output.
As i'm only running fuel on the MS and using the stock honda cdi ignition box, presumably i connect this wire to the cdi box, but to where?, tacho feed or coil feed?
Ash.
wiring question
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: wiring question
If that goes to pin 36, don't connect it to anything.
-
birdrush
- MegaSquirt Newbie
- Posts: 4
- Joined: Fri Mar 24, 2006 2:02 am
- Location: Croxley Green, Herts, UK.
Re: wiring question
Have left it out and connected the tacho input to the tacho output from the CDI box, Correct??
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: wiring question
That sounds correct.