high and low imp injectors
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
jonny5_6977
- MegaSquirt Newbie
- Posts: 6
- Joined: Tue May 09, 2006 2:59 pm
- Location: crete il
- Contact:
high and low imp injectors
i have a ms2 v3 code 2.862. i have been running high imp injectors and was now planning on running low imp injectors. i dont know if i need a daughter card or to disable it or what. the manual says something about it but their is a misprint and dosent make alot of sense to me.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: high and low imp injectors
V3.0 boards normally have the flyback board built in, so you just need to enable PWM current limiting in the software.
-
jonny5_6977
- MegaSquirt Newbie
- Posts: 6
- Joined: Tue May 09, 2006 2:59 pm
- Location: crete il
- Contact:
Re: high and low imp injectors
im not seeing a place to enable it. i know under injector characteristics i can change it. it is set to current 100% and time is 25.4. i know the site with the injectors say the peak setting is 4 amp and hold is 1 amp
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: high and low imp injectors
You are in the right place to enable it. Start with a time threshold of 1.0 and 25% current limiting.jonny5_6977 wrote:im not seeing a place to enable it. i know under injector characteristics i can change it. it is set to current 100% and time is 25.4. i know the site with the injectors say the peak setting is 4 amp and hold is 1 amp
-
jonny5_6977
- MegaSquirt Newbie
- Posts: 6
- Joined: Tue May 09, 2006 2:59 pm
- Location: crete il
- Contact:
Re: high and low imp injectors
ahh. i read it as that i needed to change the software, like in m/t config thing or something to that effect. sweet i can manage that. thanks for the help.