I am new to this. I am working on the SAE supermileage competition as well as many others on this site. I can not seem to find a starting point for a VE table. The specs for our engine is outside the limits of the VE generator.
Specs
3.5Hp @3600 RPM
4.8 ft lb @2800 RPM
redline ~4000RPM
idle 800 RPM
Do I even need a VE table? How does the Alpha N work?
Thanks for any and all help.
Need some help setting up
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Master Squirter
- Posts: 475
- Joined: Thu Oct 29, 2009 12:54 pm
Re: Need some help setting up
rcotton,
You will have to tune the VE table to match your application.
Start with: http://www.megamanual.com/begintuning.htm#fuel
and: http://www.megamanual.com/ms2/configure.htm#settables
and: http://www.megamanual.com/ms2/tune.htm#ve
Lance.
You will have to tune the VE table to match your application.
Start with: http://www.megamanual.com/begintuning.htm#fuel
and: http://www.megamanual.com/ms2/configure.htm#settables
and: http://www.megamanual.com/ms2/tune.htm#ve
Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
Re: Need some help setting up
Thanks Lance
Re: Need some help setting up
The VE table generator will not work for my application. The engine dimensions and power/torque is outside of the parameters that the VE table generator calculates
MS II Hardware 2.2 Software 3.0
MS II Hardware 2.2 Software 3.0