In the ms wiring diagram injector pins 32 and 33 (and 34 and 35) are bridged together. Is this necessary? I'm connecting MS to my stock L-jet wiring harness and there is has separate wires for each injector. So my question is, is it safe to connect the injectors like so:
pin 32 - injector 1
pin 33 - injector 2
pin 34 - injector 3
pin 35 - injector 4
Keep injector pins 32-35 seperate?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Master Squirter
- Posts: 475
- Joined: Thu Oct 29, 2009 12:54 pm
Re: Keep injector pins 32-35 seperate?
MadMax78,
Yes, you can do this. It works fine for 4 cylinders.
When you have an odd number of cylinders this doesn't work so well, because the point of bridging the pins is to even the electrical load on the connector pins (the pins are rated at 5 Amps each).
With 4 cylinders and one pin per injector, the load should be balanced anyhow, so you don't need to bridge the pins.
Lance.
Yes, you can do this. It works fine for 4 cylinders.
When you have an odd number of cylinders this doesn't work so well, because the point of bridging the pins is to even the electrical load on the connector pins (the pins are rated at 5 Amps each).
With 4 cylinders and one pin per injector, the load should be balanced anyhow, so you don't need to bridge the pins.
Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
Re: Keep injector pins 32-35 seperate?
Thanks for the quick and helpfull reply!
Just finishing up on my final wiring diagram now
Just finishing up on my final wiring diagram now