Warmup Wizard
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Warmup Wizard
The blocks "Priming Pulse" and "Afterstart Enrichment" are not available for me to edit in Warmup Wizard. Did I miss something in my reading?
48 Chev Pick Up, 455 Olds Motor, MSII V3, MSD Ign, TunerStudio MS, Emb Code V2.920, LC1 WB, VR with 36-1 Wheel
Re: Warmup Wizard
Look at you general fuel settings. You should have a choice of using tables for those things or just two points. Where you input you settings will depend on what you chose in the general settings. If you pick tables then you need to go to "other tables" to adjust ASE and Prime Pulse. I use TS, but I think MT is the same.
Brian
Brian
MS2 code2.89 on PCB v3.0
Re: Warmup Wizard
That was what I was missing - Thanks a lot! More fun for today!
48 Chev Pick Up, 455 Olds Motor, MSII V3, MSD Ign, TunerStudio MS, Emb Code V2.920, LC1 WB, VR with 36-1 Wheel