Automatic Mixture Control and Alpha-N

For discussing B&G MS-I/MS-II set-up and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
BCM
MegaSquirt Newbie
Posts: 4
Joined: Tue Jul 15, 2008 1:01 pm

Automatic Mixture Control and Alpha-N

Post by BCM »

I'll be running pure Alpha-N on my engine - Is there any reason that AMC would not work? My guess is that is should work fine, but everything I've seen about it refers to use w/ MAP.

My setup is MSII 3.0, with the latest code just loaded...

Thanks in advance.

Brendan
Top
grippo
Site Admin
Posts: 286
Joined: Mon Feb 16, 2004 6:55 pm

Re: Automatic Mixture Control and Alpha-N

Post by grippo »

Yes AMC should work with alpha N, it just uses tps as the table index. There is also a table you input that connects tps to an equivalent map value.
Top
Post Reply

Return to “Tuning Fuel and Air”